Comparison ledger
Heller 1707 EXL Reflow Soldering, Juki JX-100 LED, side by side. Every value shown is drawn from the cited encyclopedia entries.
| Attribute | JX-100 LEDJuki | |
|---|---|---|
| OEM | Heller | Juki |
| Category | Assembly / SMT | Assembly / SMT |
| Wafer size | — | — |
| Process node | — | — |
| Introduced | — | — |
| Production run | — | — |
| Lifecycle | — | — |
| Lifecycle milestones | — | — |
| Control system | — | — |
| Generation | — | — |
| Family | — | Juki JX-100 LED |
| Specifications | ||
| Make | Heller[1] | — |
| Model | 1707 EXL[1] | — |
| Machine type | Reflow soldering machine / reflow soldering oven[1] | — |
| Vintage | 2005[1] | — |
| Power input | Standard 208/240 VAC 3-phase[2] | — |
| Breaker size | 100 amps @ 480 V[2] | — |
| Optional power inputs | 380/400/440/415/480 VAC[2] | — |
| Frequency | 50/60 Hz[2] | — |
| Overall length | 134 in (340 cm)[2] | — |
| Overall width | 54 in (137 cm)[2] | — |
| Overall height | 63 in (160 cm)[2] | — |
| Typical net weight | 3000 lbs (1360 kg)[2] | — |
| Operating system | Windows XP[2] | — |
| Top heating zones | 7[2] | — |
| Bottom heating zones | 7[2] | — |
| Cooling zones | 1[2] | — |
| Heater type | Instant response open coil[2] | — |
| Heater material | Nichrome[2] | — |
| Temperature range | 25-350°C standard; high temperature up to 450°C optional[2] | — |
| Maximum conveyor speed | 74 in/min (188 cm/min)[2] | — |
| Board size | — | Min.50×50 ~ Max.360x800MM[3] |
| Component Size | — | Min. 0603mm(0201 Inch) ~ Max. □33.5mm[3] |
| Placement speed | — | 15,300CPH[3] |
| Board size range | — | Min 50 mm × 50 mm to Max 800 mm × 360 mm (when sent through twice; when sent through once, maximum length is 410 mm × 360 mm)[4] |
| Component size range | — | Min 0603 mm (0201 inch) to Max □33.5 mm[4] |
| Component height | — | 12.0 mm (becomes 9.0 mm when board’s X-directional length exceeds 630 mm)[4] |
| Placement speed (chip, optimized) | — | 19,300 CPH[4] |
| Placement speed (IPC9850) | — | 15,300 CPH[4] |
| Placement accuracy | — | ±0.05 mm (±3σ)[4] |
| Component centering device | — | Laser centering (LNC60)[4] |
| Feeder inputs | — | Max 30 8mm tape feeders (60 with optional rear bank)[4] |
Plan your fab
Building a Assembly / SMT process? Get a complete equipment list.
Open the fab equipment planner →